Stafford sits about 9 km north of the Brisbane CBD, inside the City of Brisbane, and its housing is more mixed than in many northern suburbs. At the 2021 Census, 66.6% of occupied dwellings were separate houses, 8.9% townhouses or similar and 24.2% flats or apartments, with an average of 2.2 people and 2.8 bedrooms per dwelling. Smaller households in smaller homes are likely to cool fewer rooms, so the sizing work tends to centre on a living area and one or two bedrooms.
Sizing starts from the room, not the brochure. Energy Rating guidance looks at floor area, wall material, insulation, windows and climate; an undersized unit works harder and may not hold temperature, while an oversized one costs more to buy and run. Brisbane appears in the hot zone of the Zoned Energy Rating Label, and the Bureau of Meteorology's Brisbane station records mean maximums of about 30 C from December to February. Once the capacity is set, the label lets you compare stars, annual energy use and the outdoor unit's noise in dB(A).
Placement is where a Stafford flat differs from a house. Under the standard body corporate by-laws, changing the external appearance of a lot needs written approval unless the change is minor and does not detract from amenity, and a scheme may run its own registered by-laws instead. Brisbane City Council sets air conditioner noise limits of 5 dBA above background from 7am to 10pm and 3 dBA from 10pm to 7am, measured at a neighbour's property, and suggests keeping equipment away from sensitive spots such as bedroom windows. In a block of units, the balcony or wall that suits the building can sit close to someone else's bedroom, so it pays to settle the position before a unit is ordered.
The electrical side applies to flats and houses alike. A licensed electrician must not do installation work in a house, flat or unit unless a safety switch protects the power point circuits or the job adds one, with limited exceptions. In a post-war Stafford house whose board has never been upgraded, that can become part of the quote, and Tom's pages say the business can remove an old unit, upgrade circuits or the switchboard where required and fit the new system. Once the circuit is connected, a certificate of testing and compliance must follow as soon as practicable.
Tom works from 10 Jacksonia Drive in Warner, so a Stafford site assessment is a booked visit rather than a same-street call.